Codonics EP-1000 Series Manuel d'utilisateur télécharger pdf

Philips Pegasys to Codonics EP

Philips Pegasys to Codonics EPPhilips Pegasys to Codonics EP

Philips Pegasys to Codonics EP-

-1000

10001000

1000

Quick Start Guide

Quick Start GuideQuick Start Guide

Quick Start Guide

Overview

The purpose of this instruction is to outline the essential steps required to set up and configure a Codonics

EP-1000 printer for operation with a Philips/ADAC Pegasys workstation. More detail can be found in other

supplied documents such as the EP-1000 Manual and Codonics Color Dye Sublimation Printers Ver. 7.0

Release Document.

The Pegasys must have Version 7 of the Codonics driver for Pegasys systems installed in order to print to

the EP-1000 printer. Driver version 7 requires Version 5 of the Pegasys software. There is no DICOM

printing option for the EP-1000. See the System Requirements section of the Codonics Color Dye

Sublimation Printers Ver. 7.0 Release Document for details.

The Add/Del Utility must be performed on the Pegasys Master system. Printer configurations can be set

up after the initial addition from any workstation.

Printer Setup

1. Remove the EP-1000 printer from its shipping box and packing. Set it in place where it will operate.

2. Remove and save the two green shipping brackets that are attached at the front of the printer, in the

media cassette slot. No tool is required to remove these brackets.

3. Remove the media cassette from the shipping box and remove all packing material from the cassette.

4. Load the media cassette as follows:

A. Press down on the spring plate of the cassette until it locks.

B. Set the green side spacers according to the paper size you are loading: down for Letter (A-size); up

for A4-size. Also set the green end stop accordingly.

C. Unwrap a 50-sheet starter paper pack included in the printer box. Place the paper into the cassette

so that the shiny side is up.

D. Insert the loaded media cassette into the front of the EP-1000.

5. Load ribbon carrier as follows:

A. Remove and unwrap the green ribbon carrier from the EP-1000 shipping box.

B. Unwrap the 50-print starter ribbon that is provided with the starter kit.

C. Snap the ribbon into the carrier. The spools are keyed so that the ribbon only goes in one way.

Refer to the picture etched on the ribbon carrier.

D. Open the printer door and insert the loaded ribbon carrier, engaging the spring-loaded gears to the

left.

6. Attach the two EP-1000 covers as follows:

A. Snap the smoky-gray cover into the slot at the rear of the printer.

B. Set the white, U-shaped cover at the front of the printer over the media cassette.

Printer Power and Test Print

1. Connect the printer power cord at the back of the EP-1000.

CAUTION: Printer must be powered with 120 vac ONLY. Connecting to any other voltage

may result in damage to the printer.

2. Make an internal test print as follows:

A. With printer power off, press and hold the ONLINE button.

B. Turn on printer power via power switch at left front.

1 2 3 4

Résumé du contenu

Page 1 - Printer Power and Test Print

Philips Pegasys to Codonics EPPhilips Pegasys to Codonics EPPhilips Pegasys to Codonics EPPhilips Pegasys to Codonics EP----1000100010001000 Quick

Page 2 - Network Connection

C. Continue to hold the ONLINE button for a few seconds. When the POWER light stops flashing, release the ONLINE button, then momentarily press the P

Page 3

set-ep1000 <enter> 4. Follow the prompts. For direct connect or isolated networks, use the following: Subnet Mask: 255.255.255.0 Gateway: 0.0.0

Page 4 - Adjusting Image Quality

7. If all printers have been configured, click Save All & Exit. If more printers must be configured, click Save and repeat this section. Restarti

Plus de documents pour Imprimer et scanner Codonics EP-1000 Series

Voir le document Codonics EP-1000 Series Manuel d'utilisateur

Codonics EP-1000 Series Manuel d'utilisateur (60 pages)

Codonics EP-1000 Series Manuel d'utilisateur (7 pages)

Commentaires sur ces manuels

Pas de commentaire

Codonics EP-1000 Series Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Imprimer et scanner Codonics EP-1000 Series. Philips (ADAC Labs) Pegasys to EP-1000 [en] Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Imprimer et scanner Codonics EP-1000 Series

Commentaires sur ces manuels